You can adjust the layout and justification of piping in a piping system.
When sections of piping are selected in a view, the following tools are activated:
- Diameter: specifies the diameter of the pipe. If connections cannot be established, a warning message appears.
- Offset: specifies the vertical elevation of the duct relative to the current level. You can enter an offset value or select from a list of remembered offset values.
On the Options Bar:
- Routing Solutions
: activates tools that let you select a routing solution that can be used to modify the selected piping. - Justify
: activates tools that let you specify the alignment of the pipe segments in a section of piping. Note: You cannot justify vertical sections or a section containing a tee fitting. - Slope:
: activates tools that let you adjust the slope for piping.
The following tools are available from the Multi-Select tab:
Connect Into - Duct/Pipe tool to automatically add a component and create piping between the new component and the existing system.